Hardware Installation; Installing The Hp Blc 4X Ddr Infiniband Gen 2 Switch; Prepare The Interconnect Module Bay In The Hp Bladesystem C7000 Enclosure; Removing A Divider From The Hp Bladesystem C7000 Enclosure Interconnect Module Bay - HP 489183-B21 - InfiniBand DDR Switch Installation Manual
Hp blc 4x ddr infiniband gen 2 switch installation guide
Hide thumbs
Also See for 489183-B21 - InfiniBand DDR Switch:
- Frequently asked questions (4 pages) ,
- Using manual (15 pages)
Table of Contents
2 Hardware Installation
This chapter contains the following sections:
•
Installing the HP BLc 4X DDR InfiniBand Gen 2 Switch
•
Installing InfiniBand cables in the HP BLc 4X DDR InfiniBand Gen 2 Switch
•
Cable Management
•
InfiniBand subnet managerment
2.1 Installing the HP BLc 4X DDR InfiniBand Gen 2 Switch
To install the HP BLc 4X DDR InfiniBand Gen 2 Switch, follow the steps in
Section
2.1.2.
Caution:
All panels and doors should be in place and securely fastened while the unit is in operation for
proper cooling and for EMI emissions control.
2.1.1 Prepare the Interconnect Module Bay in the HP BladeSystem c7000 Enclosure
To prepare the interconnect module bay in the HP BladeSystem c7000 enclosure, follow these
steps:
1.
Remove any devices or blanks.
2.
To remove the divider, press the divider release button (see callout 1 in
the divider out of the interconnect module bay (see callout 2 in
Figure 2-1 Removing a Divider from the HP BladeSystem c7000 Enclosure Interconnect Module Bay
The following list describes the callouts shown in
1.
Press the divider release button.
2.
Slide divider out from the interconnect module bay.
(Section
2.3)
(Section
2
1
(Section
2.4)
Figure
2-1:
2.1 Installing the HP BLc 4X DDR InfiniBand Gen 2 Switch
2.1)
(Section
2.2)
Section 2.1.1
and
Figure
2-1) and slide
Figure
2-1).
11
Table of Contents
