Configuration Commands; Introduction; Viewing And Saving Changes; Saving The Configuration - HP 445860-B21 - 10Gb Ethernet BL-c Switch Reference Manual

Hp 10gb ethernet bl-c switch iscli reference guide
Hide thumbs Also See for 445860-B21 - 10Gb Ethernet BL-c Switch:
Table of Contents

Configuration Commands

Introduction

The Configuration commands are available only from an administrator login. They include commands for
configuring every aspect of the HP 10GbE switch . Changes can be saved to non-volatile memory
(NVRAM).
The following table describes the basic Configuration commands. The following sections provide more
detailed information and commands.
Configuration commands
Table 75
Command
show running-config
copy running-config {ftp|tftp}
copy {ftp|tftp} running-config

Viewing and saving changes

As you use the configuration commands to set switch parameters, the changes you make take effect
immediately. You do not need to apply configuration changes when you use the ISCLI. Any changes are
lost the next time the switch boots unless the changes are explicitly saved.

Saving the configuration

You must save configuration changes to flash memory, so the switch reloads the setting when you reset
the switch.
IMPORTANT:
To save the new configuration, enter the following command at any prompt:
Switch# copy running-config startup-config
When you save configuration changes, the changes are saved to the active configuration block.
For instructions about selecting the configuration to run at the next system reload, see the "Selecting a
configuration block" section in the "Boot Options" chapter.
If you do not save the changes, they are lost the next time the system is reloaded.
Usage
Dumps current configuration to a script file.
Command mode: All
Backs up current configuration to FTP/TFTP server.
Command mode: All
Restores current configuration from FTP/TFTP server.
Command mode: All
Configuration Commands
101
Table of Contents
loading

Table of Contents