Rip Configuration Example - HP 438031-B21 - 1:10Gb Ethernet BL-c Switch Application Manual
Hp 1:10gb ethernet bl-c switch for c-class bladesystem application guide
Hide thumbs
Also See for 438031-B21 - 1:10Gb Ethernet BL-c Switch:
- Reference manual (252 pages) ,
- Command reference manual (208 pages) ,
- Cli reference manual (190 pages)
Table of Contents
RIP configuration example
NOTE:
An interface RIP disabled uses all the default values of the RIP, no matter how the RIP
parameters are configured for that interface. RIP sends out RIP regular updates to include an Up
interface, but not a Down interface.
1.
Add VLANs for routing interfaces.
>> Main# cfg/l2/vlan 2/ena
>> VLAN 2# add 20
Port 20 is an UNTAGGED port and its current PVID is 1.
Confirm changing PVID from 1 to 2 [y/n]: y
>> VLAN 2# /cfg/l2/vlan 3/ena
>> VLAN 3# add 21
Port 21 is an UNTAGGED port and its current PVID is 1.
Confirm changing PVID from 1 to 3 [y/n]: y
2.
Add IP interfaces to VLANs.
>> Main# cfg/l3/if 2/ena
>> IP Interface 2# addr 102.1.1.1
>> IP Interface 2# vlan 2
>> IP Interface 2# /cfg/l3/if 3/ena
>> IP Interface 3# addr 103.1.1.1
>> IP Interface 3# vlan 3
3.
Turn on RIP globally and enable RIP for each interface. IP Forwarding must be on
(/cfg/l3/frwd/on) before you turn RIP on.
>> Main# cfg/l3/rip on
>> Routing Information Protocol# if 2/ena (Enable RIP on IP interface 2)
>> RIP Interface 2# ..
>> Routing Information Protocol# if 3/ena (Enable RIP on IP interface 3)
>> RIP Interface 3# apply
>> RIP Interface 3# save
Use the /maint/route/dump command to check the current valid routes in the routing table of the
switch.
For those RIP learned routes, within the garbage collection period, that are routes phasing out of the
routing table with metric 16, use the /info/l3/rip/routes command. Locally configured static routes
do not appear in the RIP Routes table.
Routing Information Protocol
(Enable VLAN 2)
(Add port 20 to VLAN 2)
(Enable VLAN 3)
(Add port 21 to VLAN 3)
(Enable interface 2)
(Define IP address for interface 2)
(Add interface 2 to VLAN 2)
(Enable interface 3)
(Define IP address for interface 3)
(Add interface 3 to VLAN 3)
(Turn on RIP globally)
(Apply your changes)
(Save the configuration)
115
Table of Contents
Troubleshooting
