802.1X Port Configuration - HP 438031-B21 - 1:10Gb Ethernet BL-c Switch Cli Reference Manual
Hp 1:10gb ethernet bl-c switch for c-class bladesystem iscli reference guide
Hide thumbs
Also See for 438031-B21 - 1:10Gb Ethernet BL-c Switch:
- Reference manual (252 pages) ,
- Command reference manual (208 pages) ,
- Application manual (195 pages)
Table of Contents
802.1x Port configuration
The 802.1x port commands allow you to configure parameters that affect the selected port in the switch.
These settings override the global 802.1x parameters.
The following table describes the 802.1x Port Configuration commands.
802.1x Port Configuration commands
Table 103
Command
dot1x mode {[force-unauthorized|
auto|force-authorized]}
dot1x quiet-time {<0-65535>}
dot1x transmit-interval
{<1-65535>}
dot1x supplicant-timeout
{<1-65535>}
dot1x server-timeout {<1-65535>}
dot1x max-request {<1-10>}
dot1x re-authentication-interval
{<1-604800>}
[no] dot1x re-authenticate
Description
Sets the type of access control for the port:
force-unauth—the port is unauthorized unconditionally.
auto—the port is unauthorized until it is successfully authorized
by the RADIUS server.
force-auth—the port is authorized unconditionally, allowing
all traffic.
The default value is force-auth.
Command mode: Interface port
Sets the time, in seconds, the authenticator waits before transmitting
an EAP-Request/Identity frame to the supplicant (client) after an
authentication failure in the previous round of authentication. The
default value is 60 seconds.
Command mode: Interface port
Sets the time, in seconds, the authenticator waits for an EAP-
Response/Identity frame from the supplicant (client) before
retransmitting an EAP-Request/Identity frame. The default value is
30 seconds.
Command mode: Interface port
Sets the time, in seconds, the authenticator waits for an EAP-
Response packet from the supplicant (client) before retransmitting
the EAP-Request packet from the authentication server. The default
value is 30 seconds.
Command mode: Interface port
Sets the time, in seconds, the authenticator waits for a response
from the RADIUS server before declaring an authentication timeout.
The default value is 30 seconds.
Command mode: Interface port
Sets the maximum number of times the authenticator retransmits an
EAP-Request packet to the supplicant (client). The default value is 2.
Command mode: Interface port
Sets the time, in seconds, the authenticator waits before re-
authenticating a supplicant (client) when periodic re-authentication
is enabled. The default value is 3600 seconds.
Command mode: Interface port
Sets the re-authentication status to on or off. The default value is
off.
Command mode: Interface port
Configuration Commands
123
Table of Contents
