Power Supply - HP dx7400 - Microtower PC Service & Reference Manual
Service reference guide - hp compaq dx7400 business pc
Hide thumbs
Also See for dx7400 - Microtower PC:
- Troubleshooting manual (69 pages) ,
- Hardware reference manual (32 pages) ,
- Utility manual (19 pages)
Table of Contents
5.
Go to step 7.
6.
If using a new heatsink, remove the protective covering from the bottom of the heatsink and place
it in position atop the processor.
7.
Secure the heatsink to the system board and system board tray with the four captive screws and
attach the heatsink control cable to the system board.
CAUTION:
X) to evenly seat the heatsink on the processor. This is especially important as the pins on the
socket are very fragile and any damage to them may require replacing the system board.
NOTE:
After installing a new processor onto the system board, always update the system ROM to
ensure that the latest version of the BIOS is being used on the computer. The latest system BIOS can
be found on the Web at: http://h18000.www1.hp.com/support/files.
Power Supply
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Remove the front bezel
4.
Rotate the drive cage to its upright position.
5.
Loosen the plastic cable fastener
plastic fastener.
6.
Unplug all power supply wires from the system board.
7.
Remove the three screws that secure the power supply to the back of the chassis (1).
8.
Remove the one screw in front of the power supply that secures the power supply to the chassis
base (1).
9.
Remove the serial port wire from on top of the power supply.
112 Chapter 8 Removal and Replacement Procedures Small Form Factor (SFF) Chassis
Heatsink retaining screws should be tightened in diagonally opposite pairs (as in an
(Access Panel on page
(Front Bezel on page
(Plastic Wire/Cable Fastener and Clips on page
(Preparation for Disassembly on page
88).
89).
87).
105) and smaller
Table of Contents
