Cisco PIX 520 - PIX Firewall 520 Online Help Manual page 147
User guide
Hide thumbs
Also See for PIX 520 - PIX Firewall 520:
- Installation manual (58 pages) ,
- User manual (24 pages) ,
- User manual (114 pages)
Table of Contents
Defining Basic Information
Follow these steps to specify the basic identification information for the host or network:
1.
To define a host or network, click Add on the Hosts/Networks tab. The Create host/network>Basic
Information dialog box appears.
2.
To specify the address used to reach the host or network, enter the address in the IP Address box.
3.
To specify the mask value that corresponds to the network or host that you are defining, click the desired
value in the Mask list. If you are defining a host, you must click the 255.255.255.255 value.
4.
If the selected interface does not correspond to the interface from which the host or network is directly
reachable, click the correct interface name in the Interface list. By default, this value is the interface
selected on the Hosts/Networks tab.
5.
To specify the name used when referencing this host or network within access or translation rules, enter the
name in the Name (Recommended) box. While this value is optional, it is recommended.
6.
To define the static routing rule for this host or network, click Next. If the selected interface is not the
inside interface, the Create host/network>Static Route dialog box appears. Otherwise, the Create
host/network>NAT (Network Address Translation) dialog box appears.
Copyright © 2001
Cisco Systems, Inc.
Table of Contents
