Table of Contents
Available languages
Available languages
Pick a location which will allow you to blow the cold
air into the area you want. Windows used for
installation must be strong enough to support: the
weight of the air conditioner. Good installation with
special attention to the proper position of the unit
will lessen the chance that service will be needed,
When cooling more than one room, installation
location is very important. To cool your rooms, cold
air must be blown from the air conditioner in a
straight path.
L_tly it is adviced to save the shpping carton for
future storage of the unit.
HOW TO INSTALL
If the air conditioner is bilked
by a storm
window frame, see step 16 on page 8 before
b_inning
to install.
_
Rernove the
which fasten the cabinet
screws
at
the back and side of the unit. Save side screws.
Discard back screws,
FIG. 3
_
Slide the unit out of the cabinet by gripping the
base pan handle and pull forward while bracing the
cab inet.
FIG. 4
Cut the FOAM SEAL (ITEM J) to fit the
underside of the window sash. Peel off the backing
and attach the FOAM SEAL as shown in Fig, 5,
Sash
FIG. 5
D
Insertthe side curtains(_TEM A) into the upperguide
and bwer gui@ on each si@ of the air conditionerca_net.
Fasten the curtainsto the unRwith_rews (ITEM E).
ITEM E
FIG. 6
_O_n
the window. Mark a line on the center of the
windowinnersi& Loosely attach the sill bracket (iTEM C)
to the support bracket (ITEM B) using the carriage bolt
(iTEM i) and the Iock nut (iTEM D).
ITEM
ITEM I
_
Attach the sill bracket to the window sill using the
screws (ITEM F). Carefully place the cabinet on the
window inner sill and align the center of the cabinet
front with the center line marked on the window inner
sill.
jMachine screw
d [l_k nut
{ITEM D)
andlocknut
ITEMF
\
Silibracket
FIG. 8
W
Using the M-screw (ITEM H) and the I_k nut
(iTEM D}, atta@ the sup_rt bracket to the cabinet:
track hole, Use the first track hole as shown. Tighten
the carriage bolt and the Iod_nut. _ sure the cabinet
slants downward 1/4" from level,
CAUTION: Do not drill a hole in the base pan. The unit
is designed to operate with approximately 1/2" of water
in base pan.
Cabinet
OUTOOOR
FIG. 9
-6-
Chapters
Table of Contents
