Rip Commands - D-Link DES-3852 - xStack Switch - Stackable Cli Manual
Xstack des-3800 series layer 3 stackable fast ethernet managed switch
Hide thumbs
Also See for DES-3852 - xStack Switch - Stackable:
- User manual (100 pages) ,
- User manual (391 pages)
Table of Contents
xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual
The RIP commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following table.
Command
config rip
enable rip
disable rip
config rip timer
show rip
Each command is listed, in detail, in the following sections.
config rip
Purpose
Syntax
Description
Parameters
Parameters
[ipif | all] {authentication [enable
16> | disable] | tx_mode [disable | v1_only | v1_compatible |
v2_only] | rx_mode [v1_only | v2_only | v1_or_v2 | disable]
state [enable | disable]}
[update_interval | timeout_interval
]
| disable] | tx_mode [disable | v1_only |
− The name of the IP interface.
− Allows the specification of a case-sensitive
65535> | garbage_collect_interval
ipif
Used to configure RIP on the Switch.
config rip [ipif | all] {authentication [enable
v1_compatible | v2_only] | rx_mode [v1_only | v2_only | v1_or_v2 |
disable] state [enable | disable]}
This command is used to configure RIP on the Switch.
all – To configure all RIP receiving mode for all IP interfaces.
authentication [enable | disable] − Enables or disables authentication for
RIP on the Switch.
•
password.
tx_mode − Determines how received RIP packets will be interpreted – as
RIP version V1 only, V2 Only, or V1 Compatible (V1 and V2). This entry
specifies which version of the RIP protocol will be used to transfer RIP
packets. The disabled entry prevents the reception of RIP packets.
•
disable − Prevents the transmission of RIP packets.
•
v1_only − Specifies that only RIP v1 packets will be transmitted.
•
v1_compatible – Specifies that only RIP v1 compatible packets
will be transmitted.
•
v2_only - Specifies that only RIP v2 packets will be transmitted.
rx_mode − Determines how received RIP packets will be interpreted – as
RIP version V1 only, V2 Only, or V1 or V2. This entry specifies which
version of the RIP protocol will be used to receive RIP packets. The
Disabled entry prevents the reception of RIP packets.
•
v1_only − Specifies that only RIP v1 packets will be transmitted.
•
v2_only - Specifies that only RIP v2 packets will be transmitted.
•
v1_or_v2 - Specifies that only RIP v1 or v2 packets will be
transmitted.
187
26
RIP C
OMMANDS
Table of Contents
