Connecting Two Data Hosts Through A Zoned Switch; Connecting Remote Management Hosts; Next Steps - HP 2000fc User Manual
Modular smart array
Hide thumbs
Also See for 2000fc:
- Reference manual (330 pages) ,
- Cli reference manual (282 pages) ,
- User manual (150 pages)
Table of Contents
Connecting Two Data Hosts Through a Zoned
Switch
Figure 3-7 shows a high-availability, dual-controller connection through a two-zone
switch. Each zone can be an independent switch (see Figure 3-6).
Figure 3-7 High-Availability Dual-Controller Connection Through a Two-Zone
Connecting Remote Management Hosts
The management host directly manages systems out-of-band over an Ethernet
network. This section describes how to connect the Ethernet cables to the
management host.
1. Connect an Ethernet cable to the Ethernet management port on each controller.
2. Connect the other end of each Ethernet cable to a network that your management
host can access (preferably on the same subnet).
Next Steps
After you have connected the management host and data hosts, you are ready to
perform first-time configuration on the storage system as described in Chapter 4.
48
HP StorageWorks 2012fc Modular Smart Array user guide • March 2008
Zone 0
Switch to Two Dual-Port Data Hosts
Zone 1
Controller A
Controller B
Table of Contents
