Table of Contents
Chapter 6
Cisco Unified Serviceability Alarms and CiscoLog Messages
Enum Definitions for IPV6AddrAttributes
Code
0
1
2
3
Recommended Action
Actions to take vary depending on the reason specified for the device unregistration. If the reason is
ConfigurationMismatch, go to the Device Configuration page in Cisco Unified CM Administration,
make a change to the Description field for this device, click Save, then reset the device. In the case of a
network connectivity or loss of KeepAlives problem, use network diagnostic tools and the Cisco Unified
CM Reporting tool to fix any reported network or Unified CM system errors. In the case of a device
rehoming to the primary Unified CM node, watch for a successful registration of the device on the
primary node. In the case of a duplicate registration request, it may be a non-malicious occurrence due
to timing of a device registering and unregistering; if duplicate registration requests continue or if the
same device has different IP addresses, confirm the IP address on the physical device itself by checking
the settings on the device (settings button). If unregistration of this device was expected, no action is
required. Also, refer to the reason code descriptions for recommended actions.
DigitAnalysisTimeoutAwaitingResponse
Cisco Unified Communications Manager sent a routing request to the policy decision point but the
request timed out without a response.
Cisco Unified Communications Manager (Unified CM) was unable to complete the routing request
before timing out. This time out could occur due to low system resources, high CPU usage, or a high
volume of call activities on this Unified CM node. Unified CM applies the Call Treatment on Failure that
is configured for the External Call Control Profile associated with this call.
Cisco Unified Serviceability Alarm Definition Catalog
CallManager/CallManager
Severity
WARNING
Routing List
SDL
SDI
Sys Log
Event Log
OL-22523-01
Reason
Unknown - The device has not indicated what this IPv6 address is used for
Administrative only - The device has indicated that this IPv6 address is used for
administrative communication (web interface) only.
Signal only - The device has indicated that this IPv6 address is used for control
signaling only.
Administrative and signal - The device has indicated that this IPv6 address is used
for administrative communication (web interface) and control signaling.
Cisco Unified Communications Manager Managed Services Guide
Warning-Level Alarms
6-231
Chapters
Table of Contents
Troubleshooting
