Table of Contents
Configuring ISDN PRI
Configure
Table 3-8
Step
1
2
3
4
5
6
7
Table 3-9 lists the supported ISDN switch types.
Table 3-9
Keyword
ISDN BRI
basic-1tr6
basic-5ess
basic-dms100
basic-net3
basic-ni
basic-ts013
3-12
Cisco AS5300 Universal Access Server Software Configuration Guide
Configuring ISDN PRI
Command
5300> enable
Password:
5300#
5300# configure terminal
Enter configuration commands, one per line. End
with CNTL/Z.
5300(config)#
5300(config)# isdn switch-type primary-4ess
5300(config)# controller t1 0
5300(config-controller)#
5300(config-controller)# pri-group timeslots 1-24
nfas_d primary nfas_interface number nfas_group
number
5300(config-controller)# controller t1 X
5300(config-controller)# pri-group timeslots 1-24
nfas_d primary nfas_interface number nfas_group
number
5300(config-controller)# Ctrl-Z
5300#
%SYS-5-CONFIG_I: Configured from console by
console
ISDN Switch Types for BRI and PRI Interfaces
Switch Type
German 1TR6 ISDN switches
AT&T basic rate switches
NT DMS-100 basic rate switches
NET3 ISDN, Norway NET3, and New Zealand NET3 switches (covers the Euro-ISDN
E-DSS1 signaling system and is ETSI-compliant)
National ISDN switches
Australian TS013 switches
Purpose
Enter enable mode (also called
privileged EXEC mode).
Enter the password.
You have entered enable mode when the
prompt changes to
.
5300#
Enter global configuration mode. You
have entered global configuration mode
when the prompt changes to
5300(config)#.
Enter your telco's switch type. See
Table 3-9 for details.
Enter controller configuration mode and
port number to configure your controller
port. The controller ports are labeled 0 to
3 on the Quad cards and 0 to 7 on the
Octal cards.
Configure all the channels for ISDN and
the Non-Facility Associated Signaling
(NFAS) primary D channel. Enter
pri-group timeslots 1-24 for T1. If E1,
enter pri-group timeslots 1-31.
Note that you also need to configure the
NFAS backup D channel to be used if the
primary D channel fails on a different
channelized T1 controller.
Repeats steps 4 and 5 to configure each
additional controller (there are 4 on
Quad cards and 8 on Octal cards).
Return to enable mode.
This message is normal and does not
indicate an error.
Table of Contents
