Adding Phones With Cisco Unified Callmanager Administration - Cisco 7961G - IP Phone VoIP Administration Manual
Unified callmanager 5.1 (sccp)
Hide thumbs
Also See for 7961G - IP Phone VoIP:
- Administration manual (210 pages) ,
- Phone manual (92 pages) ,
- Datasheet (8 pages)
Table of Contents
Adding Phones to the Cisco Unified CallManager Database
Note
Note
Adding Phones with Auto-Registration and TAPS
Cisco Unified IP Phone 7961G/7961G-GE and 7941G/7941G-GE Administration Guide for Cisco Unified CallManager
2-14
Chapter 2
You should use auto-registration to add less than 100 phones to your network. To
add more than 100 phones to your network, use the Bulk Administration Tool
(BAT). See the
"Adding Phones with BAT" section on page
In some cases, you might not want to use auto-registration: for example, if you
want to assign a specific directory number to the phone or if you plan to
implement authentication or encryption, as described in Cisco Unified
CallManager Security Guide. For information about enabling auto-registration,
refer to "Enabling Auto-Registration" in the Cisco Unified CallManager
Administration Guide.
Cisco Unified CallManager automatically disables auto-registration if you
configure the cluster-wide security mode for authentication and encryption
through the Cisco CTL client.
Related Topics
Adding Phones with Auto-Registration and TAPS, page 2-14
•
Adding Phones with Cisco Unified CallManager Administration, page 2-15
•
Adding Phones with BAT, page 2-16
•
TAPS, the Tool for Auto-Registered Phones Support, works with the Bulk
Administration Tool (BAT) to update a batch of phones that were already added
to the Cisco Unified CallManager database with dummy MAC addresses. You
use TAPS to update MAC addresses and download pre-defined configurations for
phones.
Preparing to Install the Cisco Unified IP Phone on Your Network
2-16.
OL-11528-01
Chapters
Table of Contents
Troubleshooting
