Connecting External Devices; Power Indicator Codes - Dell PowerVault DL2000 Hardware Owner's Manual
Dell storage system hardware owner's manual
Hide thumbs
Also See for PowerVault DL2000:
- Getting started with your system (148 pages) ,
- Getting started manual (70 pages) ,
- Supplementary manual (2 pages)
Table of Contents
11
video connector
13
Dell remote access controller
(optional)
Connecting External Devices
When connecting external devices to your system, follow these guidelines:
•
Most devices must be connected to a specific connector and device drivers
must be installed before the device operates properly. (Device drivers are
normally included with your operating system software or with the device
itself.) See the documentation that accompanied the device for specific
installation and configuration instructions.
•
Always attach external devices while your system and the device are turned off.
Next, turn on any external devices before turning on the system
(unless the documentation for the device specifies otherwise).
For information about individual connectors, see "Jumpers and Connectors"
on page 157. For information about enabling, disabling, and configuring
I/O ports and connectors, see "Using the System Setup Program" on page 45.
Power Indicator Codes
The power button on the front panel controls the power input to the system's
power supplies. The power indicator lights green when the system is on.
The indicators on the redundant power supplies show whether power is
present or whether a power fault has occurred (see Figure 1-4). Table 1-4 lists
the power supply indicator codes.
18
About Your System
12
serial connector
Table of Contents
Troubleshooting
