Front Bezel - HP xw9400 Service And Technical Reference Manual
Hp xw9400: reference guide
Hide thumbs
Also See for xw9400:
- Hardware setup manual (56 pages) ,
- Quickspecs (47 pages) ,
- Setup manual (44 pages)
Table of Contents
WARNING!
powered off and that the power cord is disconnected from the electrical outlet.
1.
Disconnect power from the system.
2.
If a lock is present, unlock the access panel
panel
(Rear panel components on page
(Kensington, or Padlock).
3.
Pull up on the handle and lift off the cover.
Figure 4-5
To replace the access panel, align the bottom groove of the access panel with the bottom edge of the
chassis. Rotate the access panel toward the chassis and press firmly until the latch engages.
Front bezel
To remove the front bezel:
1.
Lift up on the three (1) tabs located on the front bezel.
2.
Rotate the front bezel away (2) from the chassis, and remove the bezel.
62
Chapter 4 Removal and replacement procedures
Before removing the workstation access panel, be sure that the workstation is
Opening the access panel
(Access panel on page
4). Also, unlock any other locks that are present
61). The keys are on the rear
ENWW
- Quick Links:
- Exploded View
- System Board Components
Hide quick links:
Table of Contents
Troubleshooting
