Table of Contents
Available languages
Available languages
Speakerphone/Answering System Volume Control
When the speakerphone is ON, adjust the volume by pressing the vol (
or ) buttons . There are eight volume levels, and each press of the volume
button adjusts the speaker volume by one level.
NOTE: You can also adjust the volume during intercom mode, and conference
mode.
Do Not Disturb (DND)
DND allows you to turn off the ringer on the base, the handsets and call
screening from the answerer at once even though the handsets and the
base have been set to High or Low. To do this,
1. In the standby mode, press the do not disturb button on the base. The
DND backlit indicator will turn on and DO NOT DISTURB shows in each
handset display.
2. To cancel, press do not disturb again.
NOTE: You can also enable DND even when there is incoming call ringing in.
NOTE: You can also enable DND to stop the call screening after the call is
taken by the answerer.
Intercom Operation
The intercom feature allows you to have a conversation with another
registered handset without tying up the telephone line. And since the
telephone line is not in use, you may still receive incoming calls.
IMPORTANT NOTE: The following procedures for the handset can ONLY
be done with a Model 21098A handset. If you are using an optional Model
21009A handset, please refer to the Section "21009A Optional Handset
Additional Instructions" in the latter part of this User's Guide.
Making An Intercom Call
Base to Handset
1. Make sure the phone is OFF (not in talk mode).
2. Press the PAGE/INT button on base. P_ shows on the display.
39
Chapters
Table of Contents
