Power On; Power Failure - D-Link DES-3226 User Manual
Layer 2 switch release 4.01
Hide thumbs
Also See for DES-3226:
- User manual (179 pages) ,
- Release note (4 pages) ,
- Reference manual (1 page)
Table of Contents
Power on
The DES-3226S Switch can be used with AC power supply 100-240 VAC, 50 - 60 Hz. The power Switch is located at the rear
of the unit adjacent to the AC power connector and the system fan. The Switch's power supply will adjust to the local power
source automatically and may be turned on without having any or all LAN segment cables connected.
After the power Switch is turned on, the LED indicators should respond as follows:
•
All LED indicators will momentarily blink. This blinking of the LED indicators represents a reset of the system
•
The power LED indicator is always on after the power is turned ON
•
The console LED indicator will blink while the Switch loads onboard software and performs a self-test. will remain ON if
there is a connection at the RS-232 port, otherwise this LED indicator is OFF
•
The 100M LED indicator may remain ON or OFF depending on the transmission speed
Power Failure
As a precaution in the event of a power failure, unplug the Switch. When the power supply is restored, plug the Switch back
in.
DES-3226S Layer 2 Fast Ethernet Switch User's Guide
5
Hide quick links:
Table of Contents
