® What The World Comes Home To Upright Frost Free Freezer Congélateur Vertical Congelador Vertical User Manual- Model #’s (Features may vary by model) HUF138PA Guide de l’Utilisateur- HUF168PA Modèles (Les caractéristiques peuvent varier en fonction du modèle) HUF205PA Manual del Usuario-...
This will reduce the possibility of danger to children. 7. When your freezer is in operation, do not touch the cold surfaces in the freezer compartment, particularly when hands are damp or wet. Skin may adhere to these extremely cold surfaces.
Page 3
English 9. Do not use any electrical device or any sharp instrument to defrost your freezer. 10. Unplug your freezer before cleaning or before making any repairs. Note: If for any reason this product requires service, we strongly recommend that a certified technician perform the service.
Table Of Contents PAGE Safety Precautions ..............1-2 Unpacking ..................4 Parts and Features ..............5 Freezer Installation ..............6 Electrical Connections ..............7 Operating Your Freezer ............8-11 Normal Operating Sounds ............11 Proper Care and Cleaning ............12 Frost-Free..................13 Extended Non-Use and Moving ..........13 Troubleshooting Guide ..............14 Warranty..................15...
2. Inspect and remove any remaining packaging, tape and printed materials before turning ON the freezer. Note: Allow the freezer to stand in an upright position for at least 24 hours before turning on the power, if the freezer has been tilted for any reason.
English Parts And Features 1. Interior Light 5. Temperature Alarm Indicator Light 2. Cabinet Wire Shelves (quantities vary 6. Power Indicator Light per model) 7. Locking Plate 3. Temperature Control Dial 8. Lock (not shown) 4. Storage Drawers (quantity varies by 9.
• The freezer is designed for freestanding installation only. It should not be built-in. • Allow a minimum of 2 inch on each side and above the top of the freezer to ease installation and allow proper air circulation. • Be sure to install your freezer on a floor that is strong enough to support the unit...
Page 8
Electrical Connection Grounding Instructions For personal safety, this appliance must be properly grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing an escape wire for the electrical current. This appliance is equipped with a cord containing a grounding wire with a grounding plug.
When turning ON your freezer, the temperature alarm system switch should be at the “O” position. Put it in the “-“ position once the freezer has been ON for a peri- od of 24 hours. The temperature alarm is activated at 15.8˚F. Once activated, the built-in audible alarm system will signal a warning to you.
Page 10
The shelves of the freezer were designed with you in mind. Their adjustability in position allows you to personalize the storage space to your specific needs. To remove or adjust a full-width, slide-out shelf: 1. Gently tilt the shelf up and slide it towards you until the shelf has been completely (see removed.
Page 11
8. Align the pin of the top hinge with the top hole on the left side of the door and push in place. Replace the screws in the upper hinge bracket but do not tighten all the way.
2. Remove the door handle by unscrewing the upper and lower screws with a Phillips screwdriver. (see fig. 7) 3. Install the handle on the right side of the door with the screws previously removed. 4. Replace the plastic screw hole covers onto the door handle.
• Carefully slide the freezer away from the wall slowly to avoid damaging the floor. • Wipe dust from the back of the freezer and the outside of the compressor com- partment with a clean dry cloth or use a vacuum cleaner with a brush attachment.
45 degrees or was laid down horizontally for any reason (e.g., shipping), the unit must not be operated for at least 24 hours. It must be placed in the upright position for 24 hours to allow the internal oil and refrigerant to stabilize in the system.
Compressor seems to run continuously or more often than necessary. • The door may have been left open or there may be a leak in the door gasket. • Frequent door openings allow cold air to escape, thus forcing the compressor to cycle ON more often.
What will be done? limitations may not apply to you. Some 1. We will repair or replace, at our dis- States do not allow limitations on how cretion any mechanical or electrical long an implied warranty lasts, so the part which proves to be defective in above limitations may not apply to you.
Page 17
IMPORTANTE No regrese éste producto a la tienda Si usted tiene problemas con éste producto, por favor contacte al "Centro de Servicio al Cliente de Haier al 1–877-337-3639. SE REQUIERE UNA PRUEBA DE COMPRA FECHADA PARA EL SERVICIO DE GARANTIA...