Adjusting The Feet; Electrical Connection - Beko WITC 7612 B0W User Manual
Hide thumbs
Also See for WITC 7612 B0W:
- User manual (57 pages) ,
- User manual (65 pages) ,
- User manual (52 pages)
Table of Contents
4.1.6 Adjusting the feet
A
CAUTION!
• In order to ensure that the product operates
more silently and vibration-free, it must stand
level and balanced on its feet. Balance the
machine by adjusting the feet. Otherwise,
the product may move from its place and
cause crushing and vibration problems.
• Do not use any tools to loosen the lock
nuts. Otherwise, they will get damaged.
1 Loosen the lock nuts on the feet by hand.
2 Adjust the feet until the product stands in a
stable and balanced way.
3. Tighten all lock nuts by hand again.
Adjusting the feet with water level
• You must remove the Detergent Drawer to
set the Water Level.
• For the system to operate properly, the bubble
inside the Water Level must be in the middle.
• If the bubble inside the Water Level is on the
left, the pre-set right foot of the Washing
Machine must be adjusted.
• If the bubble inside the Water Level is on the
right, the pre-set left foot of the Washing
Machine must be adjusted.
• If the bubble inside the Water Level is at the
back, the pre-set front feet of the Washing
Machine must be turned to the left (clockwise).
• If the bubble inside the Water Level is at the
front, the pre-set front feet of the Washing
Machine must be turned to the right (anti-
clockwise).
8 / EN
4.1.7 Electrical connection
Connect the product to a grounded outlet
protected by a 16 A fuse. Our company shall
not be liable for any damages that will arise
when the product is used without grounding in
accordance with the local regulations.
• Connection must comply with national regulations.
• The wiring for the electrical outlet circuit
must be sufficient to meet the appliance
requirements. Use of a Groud Fault Circuit
Interrupter (GFCI) is recommended.
• Power cable plug must be within easy reach
after installation.
• If the current value of the fuse or breaker
in the house is less than 16 Amps, have a
qualified electrician install a 16 Amp fuse.
• The voltage specified in the "Technical
specifications" section must be equal to
your mains voltage.
• Do not make connections via extension
cables or multi-plugs.
A
CAUTION!
• Damaged power cables must be replaced
by the Authorised Service Agents.
4.1.8 Initial use
and Environment Instructions" and the
instructions in the "Installation" section.
To prepare the product for washing laundry,
perform first operation in Drum Cleaning
programme. If this program is not available
in your machine, apply the method which is
described in the section 4.4.2.
C
INFORMATION
• Use an anti-limescale suitable
for the washing machines.
• Some water might have remained in the
product due to the quality control processes in
the production. It is not harmful for the product.
Washing Machine / User Manual
Before starting to
use the product
make sure that
the preparations
are made which
are in line with the
"Important Safety
Table of Contents
