F) CARE OF FILTERS
The vacuum cleaner has two filters, one central filter
installed in the dust bag compartment that protects
the motor (Fig. 1). The other, clean air filter (electro¬
static), is installed in the exhaust cover situated in the
top rear side of your cleaner, and it retains any small
dust particles which may be present in the exhausted
air (Fig. 2).
It is advisable to change the clean air filter when it
becomes dirty. As a guide, once or twice a year is
usually sufficient.
When you change the clean air filter (non washable),
we advise that the central filter is washed. Simply
rinse it out in warm water and dry thoroughly before
replacing.
CENTRAL FILTER (Fig. 1) Part no. AMC8GF03D1000
To remove the central filter, hold at the top (as illus¬
trated) and pull it up.
Important:
Ensure that the filter is dry before
re-installing it into the cleaner.
CLEAN AIR FILTER (Fig. 2, Fig. 3)
Part no. AMC8GF28D1000
To change the clean air filter, lift up the exhaust cover
and remove the filter support as shown in Fig. 2 and
Fig. 3.
IMPORTANT:
before use.
Do not forget re-install the filters
Panasonic Australia PTY Limited
1 Garigal Road
BELROSE NSW 2085
AUSTRALIA
Fisher & Paykel
Customer Services Division
PO Box 14-444
Panmure
AUCKLAND - NEW ZEALAND
Z07D9090
