Table of Contents
1
9 transport,
Storage and disposal
19.1 Prepare the device for
transport
DANGER!
If the device is operated immediately
after transport, the coolant contained
in the device can cause damage to the
device.
Immediately after transport, let the
▶
device rest for two hours before
putting it into operation.
Tip:The device may contain residual
water and drip during transport.
Transport the device standing up.
requirements
¡The condensation water container is
empties. Empty the condensation water
container → Page 37
¡The device is switched on.
→
"Switch on the device", page 33
Set any program → Page 33 .
1.
Start the program → Page 34 and
2.
wait 5 minutes.
aThe condensation has drained
pumps.
Put the device into standby mode.
3.
→ ""Set the device to standby
mode", page 35
Remove the water drain hose
4.
from the connection point.
→
"Water drain connection types",
page 15
Secure the water drain hose on the
5.
device against accidental
loosening.
Transport, storage and disposalde
Make sure not to kink the water
drain hose.
Empty the condensation water
6.
container → Page 37 .
Push in the condensation water
7.
container → Page 37 .
Disconnect the device's power plug
8th.
from the power supply.
aThe device is ready for transport.
19.2 Dispose of old device
Valuable raw materials can be
reused through environmentally
friendly disposal.
WARNING
Risk of damage to health! Children can
become trapped in the device and
endanger their lives.
Do not place the device behind a
▶
door that blocks or prevents the
device door from opening.
For old devices, pull the power plug
▶
of the power connection cable, then
cut the power connection cable and
destroy the lock on the device door
to such an extent that the device
door no longer closes.
WARNING
Danger of fire!
The refrigerant R290 in this device is
environmentally friendly but
flammable and can ignite if the device
is not disposed of properly.
Dispose of the device properly.
▶
Do not damage the refrigerant
▶
circuit pipes.
Pull out the mains plug of the
1.
mains connection cable.
Cut the mains connection cable.
2.
Dispose of the device in an environmentally friendly
3.
manner.
53
Table of Contents
