Quick Links
STEREO SYSTEM RACK
:
ORC-405¢ /445 ©
ASSEMBLY INSTRUCTIONS
IMPORTANT:
* Before operating your new KENWOOD product, read through this assem-
bly manual carefully to get the most out of it.
*-Save this assembly instructions.
Before Assembling
¢ A Phillips screwdriver and a mallet are required for assembling.
* Be careful not to damage the floor and rack.
A\ Caution : Read this page carefully to keep your safety.
Please eae all of the safety and opetating instructions before operating this unit.
mo
For best ri.
and use ir
future ret. _
'ts, follow all warnings placed on the unit and adheré to the operating
~~
otions. These safety and operating instructions should be retained for
08,
we
i.
1. Suffocation — After taking the ne out of the polyethylene bag, be sure to di-
spose of the polyethylene bag out of the reach of children. Otherwise, they may
play with the bag, which could cause hazard of suffocation.
2. Water and moisture — Do not place a liquid container, such as a vase and water
basin, on the unit. Also avoid installing the unit in a place subject to dampness.
CF
3. Heat — Do not install the unit near a source of heat, such as a heater, or under
direct sunlight.
KENWOOD
KENWOOD
CORPORATION
© PRINTED IN U.S.A.
B61-0727-00
Ro460
Notes on Assembling
* During assembling, be sure to verify the numbers stamped on the boards.
* Mount the rear panel after assembling the side pane! on the bottom shelf
ata right angle.
* When mounting the top shelf and kick plate on the side panel, use glue
for adhesive. Be sure to remove any excess glue before it dries.
Handling Precautions
;
* Tempered glass is used for the glass doors for providing sufficient strength.
However, pay attention not to apply excessive force or to scratch the
doors. Cracking or breaking of the glass may occur.
* When moving the cabinet, remove all the components from the rack be-
fore carrying the cabinet. Also do not grasp the top shelf when carrying.
* To allow heat radiation from the components, leave a space of 4 inches
between the cabinet and wall.
* Do not place the cabinet in a location subject to direct sunlight or near
a heater, an air-conditioner, or a place with high humidity.
4. Impact — Avoid placing the unit on an Uistable gurface. Install It on a hotizontal
sutface not subject to excessive dirt or vibrations ihe
=
Pee
+
f
}
°F AAR
} +3
.
;
e
:
me , .
5
Fy
ees
5. Modification — Do not attempt to open or modify the unit, for this could cause
fire hazard or malfunction.
6. Cleaning — Do not use thinner, benzine or alcohol. When cleaning the unit, wipe
with a soft, dry cloth.
7. Abnormal smell — In the event the unit generates smoke or abnormal smell, im-
mediately switch the power OFF and unplug the power cord. After this, please
contact your dealer or nearest service station as soon as possible.
POWER OFF!
