Table of Contents
Power interposer board
Removing the power interposer board
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the air
shroud.
4. Remove the
PSU
or
PSU
Steps
1. Using a Phillips #2 screwdriver, remove the screws securing the power interposer board (PIB) to the system.
NOTE:
Observe the routing of the cable as you remove it from the system.
2. Press the blue release latch on the PIB to release it from the hook on the PSU cage.
Figure 94. Removing the power interposer board
3. Lift the PIB away from the system.
Next steps
Replace the power interposer
Installing the power interposer board
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
Steps
1. Align the slots on the PIB with the hook on the PSU cage and slide it into place.
94
Installing and removing system components
Safety
instructions.
Before working inside your
blank.
board.
Safety
instructions.
Before working inside your
system.
system.
Table of Contents
