Wake-On Lan; Power-On Sequence - HP t730 Thin Client Troubleshooting Manual

Wake-on LAN (WOL) allows a computer to be turned on or resumed from sleep or hibernation state by a

network message. You can enable or disable WOL in Computer Setup using the S5 Maximum Power Savings

setting.

To enable or disable WOL:

1.

Turn on or restart the computer.

2.

Press either

bottom of the screen.

NOTE:

press

esc

3.

If you pressed esc, press

4.

Navigate to Power > Hardware Power Management.

5.

Set S5 Maximum Power Savings as follows:

●

Disable WOL = Enabled

●

Enable WOL = Disabled

6.

Press

F10

7.

Select File > Save Changes and Exit.

At power-on, the flash boot block code initializes the hardware to a known state, then performs basic power-

on diagnostic tests to determine the integrity of the hardware. Initialization performs the following functions:

1.

Initializes CPU and memory controller.

2.

Initializes and configures all PCI devices.

3.

Initializes video software.

4.

Initializes the video to a known state.

5.

Initializes USB devices to a known state.

6.

Performs power-on diagnostics. For more information, see "Power-On Diagnostic Tests".

7.

The unit boots the operating system.

esc

or

F10

while the "Press the ESC key for Startup Menu" message is displayed at the

If you do not press

esc

or

or

F10

when the monitor light turns green to access the utility.

F10

to enter Computer Setup.

to accept any changes.

F10

at the appropriate time, you must restart the computer and again

Wake-on LAN

35