Table of Contents
Available languages
Available languages
Gear Housing
Drive Shaft
Assembly
Hanger
INSTALLING / REMOVING THE ATTACHMENT
WARNING:
Read and understand operator's manual
for unit to be used with this attachment prior to
operation.
WARNING:
To avoid serious personal injury and
damage to the unit, shut unit off before removing or
installing attachments.
Installing the attachment:
NOTE: To make installing or removing the attachment easier, place
the unit on the ground or on a work bench.
1.
Remove the hanger from the top of the shaft housing.
2.
Turn knob counterclockwise to loosen (Fig. 1).
Tighten
3.
While firmly holding the attachment, push it straight into the coupler
until the release button snaps firmly into the primary hole (Fig. 2).
NOTE: Aligning the release button with the guide recess will help
installation (Fig. 3).
CAUTION:
Lock the release button in the primary
hole (Fig. 2) and securely tighten the knob before
operating this unit.
KNOW YOUR UNIT
Indexing Ring
Adjustment Bolt
Angle
Adjustment
Handle
ASSEMBLY INSTRUCTIONS
Loosen
Knob
Fig. 1
Blade
WARNING:
DO NOT USE an extension boom with
this product. It is not designed to be used with an
extension and using one may cause serious injury.
Craftsman Convertible™
Coupler
Primary Hole
Upper Shaft
Housing
Knob
Craftsman Convertible™
Coupler
4.
Turn the knob clockwise to tighten (Fig. 1).
CAUTION:
The attachments with the coupler system
are to be used in the primary hole only. Using the wrong
hole could lead to personal injury or damage to the unit.
Release Button
Lower Shaft
Housing
Fig. 2
Release Button
Guide Recess
Knob
Fig. 3
5
Hide quick links:
Table of Contents
