Table of Contents
StarBoard Link EZ2
3.3.2 Using the Electronic Pen
To use the electronic pen to draw characters or images, place the tip of the electronic pen on
the projection area and then move the pen. When you release the tip of the electronic pen from
the projection area, the writing is complete. Be careful of the following two points when using
the electronic pen.
(1) When drawing with the electronic pen, keep the pen as perpendicular as possible to the
projection area, and apply pressure to the tip of the pen so it is pressed against the
projection area.
(2) A miniature transmitter is embedded in the tip of the electronic pen. If you hold the transmitter
area of the electronic pen while drawing characters or images, the drawing data from the
electronic pen might not be transmitted correctly. If the characters or images drawn on the
projection area are not imported correctly into the PC, change your grip on the electronic pen
and then verify that they are displayed correctly.
Blocking of the Infrared Beam
Electronic pen operations are detected when the digitiser reads the infrared beams that are
generated by the pen. If the beam between the electronic pen and the digitiser is blocked,
normal input becomes impossible. Avoid blocking them during use.
3-7
How to use
English
Table of Contents
