Page 1
HP MSM310/320 APs Installation Guide Abstract This document describes how to install and initially configure the HP MSM310/320 Access Points (hereafter referred to as the AP). Professional wireless and electrical equipment experience is required. The main configuration information for autonomous mode is found in the MSM3xx / MSM4xx APs Configuration Guide.
Step 6: Assign an IP address to the AP.................11 Step 7: Test the wireless network..................12 Step 8: Perform additional configuration................12 4 Support and other resources..............14 Online Documentation......................14 Contacting HP........................14 HP Websites..........................14 Typographic conventions......................14 A Regulatory information................15 Notice for U.S.A........................15 Manufacturer's FCC Declaration of Conformity statement............15 FCC Class B statement......................15...
Page 4
Turkish recycling notice......................18 Vietnamese Information Technology and Communications compliance marking.......18 B Recycle statements..................19 Waste Electrical and Electronic Equipment (WEEE) statements............19 English recycling notice......................19 Bulgarian recycling notice....................19 Czech recycling notice......................19 Danish recycling notice.......................19 Dutch recycling notice......................19 Estonian recycling notice.....................20 Finnish recycling notice.......................20 French recycling notice.......................20 German recycling notice.....................20 Greek recycling notice......................20...
The MSM310 and MSM320 are certified under the SpectraLink Voice Interoperability for Enterprise Wireless (VIEW) Certification Program when it operates in autonomous mode or in controlled mode in conjunction with an MSM7xx Controller. Product models This document applies to these HP APs: Model Japan MSM310 J9379A/B J9374A/B...
The AP is starting up. If the Power light continues to blink after several minutes, it indicates that the software failed to load. Reset or power cycle the AP. If this condition persists, contact HP Support. Ethernet The port is not connected or there is no activity.
Failure to do so may result in personal injury, fire, equipment damage, or a voided warranty. The HP hardware warranty provides no protection against damage caused by static discharge or a lightning strike.
Equipment AC Adaptor, Sparkle Co. Inc., Models FSP015- 1 AD201A or FSP015-DYAA1xx, rated output 5 Vdc, 3A (marked Class 2 or LPS) available as HP part number J9405A. As an alternative, the MSM310/MSM320 may be connected to an external PoE source.
0.9 kg (2 pounds). Allow extra weight for cables. Powering the AP The AP can be powered by: A 10/100 or 10/100/1000 PoE-enabled switch. PoE-enabled switches are available from An HP 1-Port Power Injector (J9407A). An HP AP Power Supply (J9405A). Powering the AP...
3 Initially Configuring (Autonomous mode) About controlled mode and autonomous mode The AP can operate in one of two modes: controlled (the default) or autonomous. Switching modes resets all configuration settings to factory defaults. Controlled mode: To become operational, the AP must establish a management tunnel with an MSM7xx Controller.
MSM3xx / MSM4xx APs Configuration Guide. To configure basic WPA protection: Select VSC > HP and then enable Wireless protection and set it to WPA. Under Mode, select WPA or WPA2, then under Key source, select Preshared key and specify a key of at least 20 characters.
Enable the wireless network interface on your computer, and verify that it is set to obtain an IP address automatically. By default, the AP creates a wireless network named HP. Connect your computer to this wireless network, specifying the preshared key you set earlier in “Step 5: Configure basic wireless...
Page 13
By default, the AP only permits traffic that is addressed to the default gateway on the network (which enables you to connect to the Internet). To enable access to other resources: Select VSC > Profiles and then select the HP profile. On the Add/Edit Virtual Service Community page clear the Wireless security filters checkbox.
4 Support and other resources Online Documentation You can download documentation from the HP Support Website at: www.hp.com/support/manuals. Search by product number or name. Contacting HP For worldwide technical support information, see the HP support Website: www.hp.com/ networking/support Before contacting HP, collect the following information:...
A Regulatory information Notice for U.S.A. Manufacturer's FCC Declaration of Conformity statement Manufacturer: Hewlett-Packard Company 3000 Hanover Street Palo Alto, CA 94304- 1 185 USA For questions regarding this declaration, contact the Product Regulations Manager at the above address. FCC Class B statement This FCC Class B device complies with Part 15 of the FCC rules.
R&TTE Directive 1999/5/EC. Compliance with these directives implies conformity to harmonized European standards (European Norms) that are listed on the EU Declaration of Conformity that has been issued by HP for this device. Countries of operation & conditions of use...
2.4 GHz operation This device may be operated outdoors or indoors in all EU and EFTA countries using the 2.4 GHz band (Channels 1 - 13), except where noted below. In France, this device may use the entire 2400 - 2483.5 MHz band (Channels 1 through 13) for indoor applications.
Notice for Taiwan DGT LPD (Low Power Device) statement Korean notices Class B equipment Turkish recycling notice Türkiye Cumhuriyeti: EEE Yönetmeliğine Uygundur Vietnamese Information Technology and Communications compliance marking Regulatory information...
B Recycle statements Waste Electrical and Electronic Equipment (WEEE) statements English recycling notice Disposal of waste equipment by users in private household in the European Union This symbol means do not dispose of your product with your other household waste. Instead, you should protect human health and the environment by handing over your waste equipment to a designated collection point for the recycling of waste electrical and electronic equipment.
Estonian recycling notice Äravisatavate seadmete likvideerimine Euroopa Liidu eramajapidamistes See märk näitab, et seadet ei tohi visata olmeprügi hulka. Inimeste tervise ja keskkonna säästmise nimel tuleb äravisatav toode tuua elektriliste ja elektrooniliste seadmete käitlemisega egelevasse kogumispunkti. Küsimuste korral pöörduge kohaliku prügikäitlusettevõtte poole. Finnish recycling notice Kotitalousjätteiden hävittäminen Euroopan unionin alueella Tämä...
Italian recycling notice Smaltimento di apparecchiature usate da parte di utenti privati nell'Unione Europea Questo simbolo avvisa di non smaltire il prodotto con i normali rifi uti domestici. Rispettare la salute umana e l'ambiente conferendo l'apparecchiatura dismessa a un centro di raccolta designato per il riciclo di apparecchiature elettroniche ed elettriche.
Romanian recycling notice Casarea echipamentului uzat de către utilizatorii casnici din Uniunea Europeană Acest simbol înseamnă să nu se arunce produsul cu alte deşeuri menajere. În schimb, trebuie să protejaţi sănătatea umană şi mediul predând echipamentul uzat la un punct de colectare desemnat pentru reciclarea echipamentelor electrice şi electronice uzate.