Table of Contents
Video
NOTE:
The video setting is visible only when a video card is installed into the system.
Table 4. Video option
Options
Primary Display
Security
Table 5. Security
Option
Admin Password
System Password
Internal HDD-1 Password
Strong Password
Password Configuration
Password Bypass
Password Change
UEFI Capsule Firmware Updates
TPM 2.0 Security
Description
Allows you to set, change, and delete the admin password.
Allows you to set, change, and delete the system password.
This option lets you set, change, or delete the password on the internal hard disk drive (HDD) of the
system.
This option lets you enable or disable strong passwords for the system.
Allows you to control the minimum and maximum number of characters that are allowed for an
administrative password and the system password. The range of characters is 4–32.
This option lets you bypass the System (Boot) Password and the internal hard drive password
prompts during a system restart.
•
Disabled—Always prompt for the system and internal hard drive password when they are set.
This option is enabled by default.
•
Reboot Bypass—Bypass the password prompts on Restarts (warm boots).
NOTE:
The system will always prompt for the system and internal hard drive
passwords when powered on from the off state (a cold boot). Also, the system will
always prompt for passwords on any module bay HDDs that may be present.
This option lets you determine whether changes to the System and Hard Disk passwords are
permitted when an administrator password is set.
Allow Non-Admin Password Changes - This option is enabled by default.
This option controls whether this system enables BIOS updates via UEFI capsule update packages.
This option is selected by default. Disabling this option blocks BIOS updates from services such as
Microsoft Windows Update and Linux Vendor Firmware Service (LVFS).
Allows you to control whether the Trusted Platform Module (TPM) is visible to the operating
system.
•
TPM On (default)
•
Clear
•
PPI Bypass for Enable Commands
•
PPI Bypass for Disable Commands
•
PPI Bypass for Clear Commands
•
Attestation Enable (default)
•
Key Storage Enable (default)
•
SHA-256 (default)
Choose any one option:
Descriptions
This field determines which video controller becomes the primary
display when multiple controllers are available in the system. If you
select a device other that what you are currently using, you have to
reconnect your video cable to your selected device.
•
Auto
•
Intel HD Graphics
System setup
39
Table of Contents
