Table of Contents
2.1 Inventory
The RPS-1000 ships with the following hardware:
•
A cabinet with all hardware assembled
•
Two keys for the front door
•
Ten 4.7K ohm end-of-line resistors
NOTE: For UL installations, 4.7kΩ end-of-line resistor (ordered separately) must be used.
•
A battery cable for batteries wired in series
2.2 Environmental Specifications
It is important to protect the RPS-1000 control panel from water. To prevent water damage, the following conditions should be observed
when installing the units:
•
Do not mount directly on exterior walls, especially masonry walls (condensation).
•
Do not mount directly on exterior walls below grade (condensation).
•
Protect from plumbing leaks.
•
Protect from splash caused by sprinkler system inspection ports.
•
Do not mount in areas with humidity-generating equipment (such as dryers, production machinery).
When selecting a location to mount the RPS-1000, the unit should be mounted where it will NOT be exposed to temperatures outside the
range of 0°C-49°C (32°F-120°F) or humidity outside the range of 10%-93% at 30°C (86°F) non-condensing.
2.3 RPS-1000 Board and Terminal Strip Description
Figure 2.1 shows the RPS-1000 circuit board including location of terminals, the DIP switch for setting module ID, and the LED.
10
Section 2: Before You Begin Installing
AC Power
N
G
L
3
2
1
LED
DIP switches
for setting ID
33
32
31
30
29
28
27
26
25
24
-
+
A
B
N.O.
C
N.C.
N.O.
C
N.C.
MAIN SBUS IN OUT
/
RELAY 1
RELAY 2
for connection
conventional
to FACP or to
relay circuits
controlling
RPS-1000 if
daisy-chained
Figure 2.1 RPS-1000 Board Layout
23
22
21
20
19
18
17
16
15
14
13
-
+
A
B
-
+
A
B
O
X
O
SBUS IN
SBUS OUT
I/O 1
I/O 2
SBUS module
regulated Flexput circuits
connections
RPS-1000 Manual — P/N 151153:R 2/15/2022
12
11
10
9
8
7
6
5
4
X
O
X
O
X
O
X
O
X
I/O 3
I/O 4
I/O 5
I/O 6
Table of Contents
