Table of Contents
Quick Links
Table of Contents
Related Manuals for Bosch NDP-5512-Z30L
Summary of Contents for Bosch NDP-5512-Z30L
- Page 1 AUTODOME IP starlight 5000i IR NDP‑5512‑Z30L Installation Manual...
-
Page 3: Table Of Contents
Attaching the Mounting Cap and the Camera Installing a Roof Mount and Camera Installing the Roof Mount Attaching the Mounting Cap and the Camera Connection Maintenance Decommissioning 10.1 Transfer 10.2 Disposal Bosch Security Systems Installation Manual 2018.06 | 1.0 |... -
Page 4: Safety
Legal information Copyright This manual is the intellectual property of Bosch Security Systems, Inc. and is protected by copyright. All rights reserved. Trademarks All hardware and software product names used in this document are likely to be registered trademarks and must be treated accordingly. -
Page 5: Important Safety Instructions
® (NEC)), Canadian Electrical Code, Part I (also called CE Code or CSA C22.1), and all applicable local codes. Bosch Security Systems accepts no liability for any damages or losses caused by incorrect or improper installation. All-pole power switch - Incorporate an all-pole power switch, with a contact separation of at least 3 mm, into the electrical installation of the building. -
Page 6: Connection In Applications
AUTODOME IP starlight 5000i IR Always use Teflon tape and sealant on connector threads of any mount (sold separately by Bosch or user-supplied). Connection in applications 24 VAC power source: This unit is intended to operate with a limited power source. The unit is intended to operate at 24 VAC (if PoE+ is not available). - Page 7 GB/T 26572 X: The content of such hazardous substance in a certain homogeneous material is above the limit defined in GB/T 26572 The manufacturing datecodes of the products are explained in: http://www.boschsecurity.com/datecodes/ Bosch Security Systems Installation Manual 2018.06 | 1.0 |...
-
Page 8: Important Notices - Illumination Safety
200mm is 2.19 based on EXEMPT Group exposure limits. The EHV based on Risk Group 1 limits is 0.386. The HD for the Exempt Group is 297 mm. These values have been summarized in the table below: 2018.06 | 1.0 | Installation Manual Bosch Security Systems... -
Page 9: Customer Support And Service
AUTODOME IP starlight 5000i IR Safety | en Customer support and service If this unit needs service, contact the nearest Bosch Security Systems Service Center for authorization to return and shipping instructions. Telephone: 800-366-2283 Fax: 800-366-1329 Email: [email protected] Customer Service... -
Page 10: Introduction
Verify that all the parts listed in the Parts List below are included. If any items are missing, notify your Bosch Security Systems Sales or Customer Service Representative. – Do not use this product if any component appears to be damaged. Please contact Bosch Security Systems in the event of damaged goods. –... -
Page 11: Product Description
The integrated, intelligent IR illuminator automatically adjusts the IR intensity according to zoom factor and field of view to ensure that the scene is illuminated uniformly. Bosch Security Systems Installation Manual 2018.06 | 1.0 |... -
Page 12: Preparing Wiring
28 m (94 ft) 45 m (150 ft) 72 m (238 ft) 183 m (603 ft) Wire Gage Note: Metric wire sizes are standard DIN sizes, ISO6722, mm². Wire diameter (mm²) 2018.06 | 1.0 | Installation Manual Bosch Security Systems... -
Page 13: Installing A Microsd Card (Optional)
Loosen the 2 Hex screws in the back of the camera housing. Remove the housing cover. 2× Insert the card into the slot. Replace the housing cover. Tighten the screws on the housing cover. Bosch Security Systems Installation Manual 2018.06 | 1.0 |... - Page 14 | Installing a microSD card (optional) AUTODOME IP starlight 5000i IR 2× 2018.06 | 1.0 | Installation Manual Bosch Security Systems...
-
Page 15: Installing A Surveillance Cabinet And Camera
Attach the hook at the end of the Safety Tether to the loop attached to the top of the camera. Connect the mating connectors on the user-supplied cables to the matching connectors on the camera. Refer to the chapter Connection for more information. Bosch Security Systems Installation Manual 2018.06 | 1.0 |... - Page 16 Place the top of the camera inside the mounting cap. Rotate the camera approximately 15 degrees in a clockwise direction to lock firmly into place. Secure the safety locking screw with the T15 Torx screwdriver. 2018.06 | 1.0 | Installation Manual Bosch Security Systems...
- Page 17 AUTODOME IP starlight 5000i IR Installing a Surveillance Cabinet and Camera | en Bosch Security Systems Installation Manual 2018.06 | 1.0 |...
-
Page 18: Installing A Roof Mount And Camera
All studs must be anchored to concrete or welded to a steel backing plate. Anchor bolts can be used for blind structures where there is no access to the rear. Apply a weatherproof sealant around each fastener hole at the mounting surface. 2018.06 | 1.0 | Installation Manual Bosch Security Systems... -
Page 19: Attaching The Mounting Cap And The Camera
To ensure a watertight seal, wrap Teflon tape four times around the threads at the end of the wall mount. Attach the mounting cap to the wall mount. Secure the locking screw with the T15 Torx screwdriver. Bosch Security Systems Installation Manual 2018.06 | 1.0 |... - Page 20 Attach the hook at the end of the Safety Tether to the loop attached to the top of the camera. Connect the mating connectors on the user-supplied cables to the matching connectors on the camera. Refer to the chapter Connection for more information. 2018.06 | 1.0 | Installation Manual Bosch Security Systems...
- Page 21 Place the top of the camera inside the mounting cap. Rotate the camera approximately 15 degrees in a clockwise direction to lock firmly into place. Secure the safety locking screw with the T15 Torx screwdriver. Bosch Security Systems Installation Manual 2018.06 | 1.0 |...
-
Page 22: Connection
4 Network device (computer with monitor, DVR/NVR, etc.) If desired, connect the alarm and/or audio wires as identified in the following table. Label ID Description Cable Wire Color ALARM_COM Alarm Communications Red ALARM_OUT Alarm Out Brown 2018.06 | 1.0 | Installation Manual Bosch Security Systems... - Page 23 Description Cable Wire Color ALARM_IN1 Alarm In 1 White ALARM_IN2 Alarm In 2 Blue AUDIO OUT Audio Out Grey Ground Black AUDIO GND Audio Ground Green AUDIO IN Audio In Purple Bosch Security Systems Installation Manual 2018.06 | 1.0 |...
-
Page 24: Maintenance
Dry the bubble thoroughly with a dry nonabrasive cloth to prevent water spots. Never scrub the bubble with any abrasive material or cleaners. Bosch recommends cleaning the exterior of the bubble with NOVUS “No. 1” Plastic Clean & Shine (or equivalent), according to manufacturer’s instructions. Refer to www.novuspolish.com to order or to find a local distributor. -
Page 25: Decommissioning
10.2 Disposal Disposal Your Bosch product has been developed and manufactured using high- quality materials and components that can be reused. This symbol means that electronic and electrical devices that have reached the end of their working life must be disposed of separately from household waste. - Page 27 Bosch Security Systems B.V. Torenallee 49 5617 BA Eindhoven Netherlands www.boschsecurity.com © Bosch Security Systems B.V., 2018...