OVERVIEW
Locating a breaker when you have to turn off a circuit can be a real problem. Take the guess work out of finding the right breaker.
EQUIPMENT RATINGS
If the device is used in a manner not specified here, then the protection provided by the device may be impaired.
No part of this device may be replaced or repaired by anyone except the manufacturer.
Technical assistance: 01 (800) 788-0233, [email protected], or www.zircon.com.
INSTALLING THE BATTERY
Lift tab on bottom end of clip to release end cap.
Slide 9 Vcc battery into compartment, terminal side first, matching (+) and (-) terminals from battery to case.
Slide the clip onto the receiver, pressing down on battery until both pieces snap together.
LOCATING A CIRCUIT
Note: A small percentage of circuit boxes are mounted with breakers oriented vertically. See diagrams for proper receiver orientation.
Connect the transmitter to a circuit you want to identify. The LED will blink approximately five seconds and then glow solid indicating the transmitter is functioning.
In a three phase application, the transmitter may be connected between any power line and neutral or from line-to-line in both wye and delta type power configurations. In no event may the Breaker ID Pro Transmitter be used where the voltage across the transmitter exceeds 277 Vca, as this will cause failure of the device with consequent damage beyond repair.
Go to the circuit panel. Turn on the receiver and hold it against the breaker as shown.
It is important to hold the receiver at an angle so that the entire CONTACT AREA of the receiver touches each circuit breaker.
Slowly scan the receiver over all breakers. This calibrates the unit. During this first pass while the unit is calibrating, the receiver may indicate more than one breaker. This is normal. If you have more than one panel, be sure to perform this step on each panel. Do not turn off the receiver.
Perform a second pass over the breakers. When the green LED glows and the buzzer sounds, you are directly over the breaker connected to the transmitter.
Turn off the breaker.
Verify that the red LED on the transmitter is off, indicating a dead circuit, before beginning work.
CLEANING AND STORING THE UNIT
Clean transmitter with dry cloth only. Do not expose product to liquids.
HELPFUL HINTS
| Situation | Probable Causes | Solutions |
| No indication, i.e., no green LED and buzzer. | | |
Multiple indications on second scan | | |
Tracing circuit connected to light fixture | | |
Receiver indicates breaker above the correct one | | |
Zircon is a registered trademark of Zircon Corporation.
Visit www.zircon.com for the most current instructions.
Model: Breaker ID Pro
Transmitter: 80-277 Vca 50-60 Hz 4 W
Receiver: 9 Vcc 14 mA
Manufacturer: ZIRCON DE MÉXICO, S.A. DE C.V.
AV. ITURBIDE # 424, COL. OBRERA, C.P. 22830, ENSENADA, Baja California
Tel.: 01 (800) 788-0233
Please read and follow these instructions prior to using the tool.
ZirconCorporation
ZirconTools | ZirconToolPro
ZirconTV
ZirconTools
www.zircon.com • [email protected]
© 2017 Zircon Corporation
Documents / Resources
References
Download manual
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Thank you! Your question has been received!
Need Assistance?
Do you have a question about the Breaker ID Pro that isn't answered in the manual? Leave your question here.