Related Manuals for Rapsody RSH-250
Summary of Contents for Rapsody RSH-250
- Page 2 Package Contents and Access Panels Package Contents Front Panel Rear Panel...
- Page 3 Used to turn on/off the power. output 5.1 channel sounds by connecting to home theater amp or receiver with round - When RSH-250 is connected to a PC using connector-shaped optical cable. USB cable, power is automatically turned on. If this button is pushed in this situation, the Power Input Terminal power is turned off.
- Page 4 USB power Caution: supply only. In this case, connect separate adapter When loading hard disk, be careful that static for home to RSH-250 to supply power. electricity is not generated around the circuit. Static electricity causes fatal damage to the circuit.
-
Page 5: Connecting Video Cable
2. If RSH-250 initial screen remains blank or shows flicker, push [TV OUT] button on RSH-250 remote controller repeatedly until normal screen is shown. RSH-250 video output mode changes upon pushing the [TV OUT] button. 3. When the screen is shown normally, adjust video output from RSH-250 SETUP menu to fit into the corresponding output mode. -
Page 6: Connecting Audio Cable
Connecting Audio Cable Note: If you connect this product to video output with USB cable connected, you cannot hear sounds. Please connect cables based on the two audio outputs as bellow: If you cannot hear sounds after optical cable connection, please check as follows: Please change audio output mode to digital in SETUP menu. -
Page 7: Remote Control
Remote Control Upper Part (Function Part) - Page 8 Remote Control Power TV OUT Switches on and off Modifies TV output supported by RSH-250 sequentially. If your TV screen fails to show images, please push this button slowly. As there are seven MENU TV output modes, you will get images by pressing Accesses menu on a DVD disk the button less than eight times.
- Page 9 Remote Control Lower Part (Playback Part)
- Page 10 Remote Control SYNC Play/Pause Used to adjust subtitle synchronization timing Start or pause playback of video, music or images. when while playing a video. You can adjust the synchronization timing by 1 second upon pushing Note: this button. All files in a folder are played sequentially. If the folder has a sub-folder in it, files in the sub-folder are also played repeatedly without limit before being stopped playing.
- Page 11 Using O.T.G. Function Before using USB O.T.G: In order to use the USB O.T.G., first partition of the hard disk loaded in RSH-250 should be formatted with FAT32. For USB devices require much power consumption, there is a need to connect extra power supply.
- Page 12 Using O.T.G. Function O.T.G. Backup...
-
Page 13: Firmware Recovery
This may take up to 30 minutes depending on the user environment. When the main body is turned off during firmware upgrade, RSH-250 system get damaged and the screen turns blank. In this situation, follow the steps below to restore firmware. - Page 14 USB O.T.G. firmware Upgrade Caution: NEVER switch off RSH-250 or disconnect USB cable during O.T.G. firmware upgrade, which may result in fatal damage to the product. Download firmware files on http://www.bull-it.ch. 4. Decompose downloaded O.T.G. firmware file and 6. Wait for firmware upgrade to be completed. NEVER turn execute [Enduser.exe].
-
Page 15: Troubleshooting
7. When O.T.G. backup fails for a USB device. * In order to use the O.T.G. function, first partition of the hard disk loaded in RSH-250 should be formatted with FAT32. * O.T.G. backup is not allowed for devices that does not support UMS(Universal Mass Storage) standard.