Table of Contents
Fault
The drying time is too
long.
Water is leaking from
the appliance.
Water overflows when
filling the water tank.
The laundry is too
damp.
Cause and troubleshooting
Insufficient air circulation at the appliance's installation
location.
Ventilate the appliance's installation location.
▶
Insufficient condensation for the automatic self-clean-
ing when permanently using the crease-removal func-
tion.
The appliance's ventilation opening is blocked.
Ensure that the ventilation opening of the appliance
▶
is kept clear.
Heat exchanger is soiled.
Running the basic appliance care programme on
▶
the appliance.
→ "Appliance care", Page 45
Appliance is not correctly aligned.
→ "Aligning the appliance", Page 16
▶
Water drain hose is not connected correctly.
Ensure that the water drain hose is connected cor-
▶
rectly.
→ "Connecting the water drain hose", Page 14
The water tank for the crease-removal function is
empty.
Fill water tank.
▶
→ "Filling the water tank", Page 39.
The water tank has been filled.
Note: The overflowing water is harmless.
Do not pour any more water into the water tank.
▶
The water tank filter is soiled.
→ "Cleaning the water tank filter", Page 48.
▶
Unsuitable programme for the type of fabric.
Set a timed programme for the subsequent drying.
▶
→ "Programmes", Page 30
There has been a power cut.
Check whether the lighting in your kitchen or other
▶
appliances are working.
The load is too large.
Observe the maximum load capacity of the
▶
→ "Programmes", Page 30.
After the end of the programme, warm laundry feels
damper than it actually is.
Troubleshooting en
53
Table of Contents
