Table of Contents
POSITION
ON
START
The key can be removed from the switch when it is in the OFF position.
HEADLIGHT SWITCH
The ignition switch must be in the ON position to operate the headlights.
Use the headlight rocker switch to operate the
headlights. There are three available settings:
• HIGH BEAM
• LOW BEAM
• OFF
Press the top of the rocker switch to place the
headlights in HIGH BEAM mode. Move the rocker
switch to the center position to place the headlights in
LOW BEAM mode. Press the bottom of the rocker
switch to turn the headlights OFF. If the headlights are
on when the ignition switch is turned off, the lights will
remain on for approximately 30 seconds.
ALL WHEEL DRIVE (AWD) SWITCH
Use the All Wheel Drive (AWD) rocker switch to
change the vehicle's driveline mode. There are two
available settings:
• All Wheel Drive (AWD)
• Two Wheel Drive (2WD)
Press the top of the rocker switch to engage All Wheel
Drive. Press the bottom of the switch to operate in Two
Wheel Drive. See the All Wheel Drive (AWD) System
section for operating instructions.
FEATURES AND CONTROLS
Electrical circuits are on. Electrical equipment can be
used.
Turn the key to the START position to engage the
electric starter. The key returns to the ON position
when released.
NOTICE
FUNCTION
41
Hide quick links:
Table of Contents
