Related Manuals for Optus Ultra WiFi Booster Gen 2
Summary of Contents for Optus Ultra WiFi Booster Gen 2
- Page 1 Quick Start Guide Let’s get your Optus Ultra WiFi Booster Gen 2 connected...
- Page 2 Push and hold the pairing button on the rear of the booster for approx 6 sec , then release. The Mesh LED should flash green. On the Optus modem press the paring button for approx 3 seconds then release. Check the WiFi LED is flashing green.
- Page 3 The product marking is located on the underside of the mesh unit. Pairing button Pinhole reset button Power toggle switch Note Please refer to the LED indicator sequence table on section 3. Wait for the light on your booster to turn solid Green. This may take up to two minutes.
- Page 4 2. Where to place your Optus Ultra WiFi Booster Gen 2 in your home After the pair process is completed, unplug the power adapter booster from the wall. Move your to an area around your home you want to improve booster WiFi coverage.
- Page 5 3. How to make sure your Optus Ultra WiFi Booster Gen 2 receives a good signal Plug your booster into a power outlet - if you don’t see a light, check that the power button is ON. Wait for the light on your booster to turn on. This may take up to 10 seconds.
-
Page 6: Troubleshooting
Troubleshooting The LED lights on the front of your booster indicate the status and strength of its connection to your modem. Status Definition Device is powered off Solid red Device is booting up Solid green Bootup complete and device is ready Power Flashing red Performing factory reset... - Page 7 Take control of your home WiFi network with My Optus app Speed testing Test the speed of your WiFi connection. 24/7 support Message us anytime for help and support in My Optus app app.optus.com.au/message or online at optus.com.au/message.