Page 1
® 19C models This document contains instructions to connect a Hitachi HM-4419D (HP 1097, NCD 19C, Cornerstone) color monitor to a PC system, using the accompanying cable and video card. Please read the documentation provided with the video card, for more instructions.
Page 2
If your are using the monitor with a PC system: If a PC video card is supplied with your HP 1097x (Hitachi HM-4419D) monitor, make sure that the “Sync-On-Green” Jumper (Usually identifiable by a Red Colored Plastic Jumper on the card) is in Engaged position, as shown in figure 2, below.
Page 3
If your are using the monitor with a PC system: If a PC video card is supplied with your Hitachi HM-4419D monitor, make sure that the “Sync-On-Green” Jumper (Usually identifiable by a Red Colored Plastic Jumper on the card) is in Removed position, as shown in figure 1, below.
3. HP1097C / HITACHI 4419D’s Back Panel Some may have 3 BNC INPUTS on the back only Attach the 5 video cable: R, G, B, H & V plugs in all 5 connectors in the back of the monitor, as follows: •...
Page 5
Press the monitor power switch (see illustration below) to ON, and adjust the monitor controls. The brightness control adjusts the brightness of the display The contrast control adjusts the light-to-dark and dark-to-light contrast of the display. The degauss button manually demagnetizes the monitor. Degaussing disperses any accumulated magnetic charge from the face of the monitor.
PC video card. Or if you need to adjust the screen’s height and width for your Hitachi HM- 4419D monitor, please locate the adjustment buttons as shown below, at the lower end portion of the monitor’s back panel (underneath the BNC connectors) and adjust...
80 Hz (not 85 Hz). In this case you need to make sure that you have a Video card with a 7272 or 1097 specification (not 7285, 7285 spec may roll on some Hitachi monitors)
Page 8
Replacement video cards for this monitor can be obtained from: www.mirage-mmc.com...