Related Manuals for Ortur Laser Master 2 PRO S2
Summary of Contents for Ortur Laser Master 2 PRO S2
- Page 1 Assembly Manual...
- Page 2 Y Aluminum Profile-540mm *1 Scale Mark 0 Corner Connectors *2 Pay attention to the notch direction!
- Page 3 X Aluminum Profile-460mm *2 Scale Mark 0 Scale Mark 0 M5×25mm Screws *2...
- Page 4 Tighten with a 2.5mm Hexagon Wrench M5 Profile Nuts *4...
- Page 5 Y Aluminum Profile-540mm *1 Scale Mark 0 Corner Connectors *2 Pay attention to the notch direction!
- Page 6 M5×25mm Screws *2 Tighten with a 2.5mm Hexagon Wrench...
- Page 7 Put X-axis assembly onto the frame Scale Mark 0 X-axis Assembly *1 Scale Mark 0...
- Page 8 Base Anchors *2 Scale Mark 0 Timing Belts *2 M5×8mm Screws *4 M5 Spacers *2...
- Page 9 The timing belt needs to pass through the wheels...
- Page 10 The timing belt must be tightened and then locked with screw! Y Limit Switch *1 M5 Profile Nuts *2 Mainboard Assembly *1 M5×8mm Screws *4...
- Page 11 M5 T-nut *1 M5 Spacers *1 M5×8mm Screws *1 Cable Loom Fixing Plate 1 *1...
- Page 12 M4×6mm Screws *2 Cable Loom Fixing Plate 2 *1...
- Page 13 Install Cable Loom Cable Loom *1...
- Page 14 M4×6mm Screws *2 Cable Tie *1...
- Page 15 M4×6mm Screws *2 Black Ground Wire The wire terminal must be inserted Cable Tie *1 into the end of the port！...
- Page 16 Cable Ties *2 Black Red Laser Wire L connect laser wire Ground Wire X connect X Y connect to Y-axis motor...
- Page 17 ( LU2-4-SF haven't this Focal Gauge & Holder, but a Focal Gauge Board ) Focal Gauge + Gauge Holder *1 Cable Tie *1 M5 T-nut *2 M5×8mm Screws *2 X connect to X-axis motor...
- Page 18 LU2-2/LU2-4-LF Laser Module Screws *2 Nuts *2 Thumb Screw *1 Laser Wire Ground Wire Cable Ties *2 3Pin...
- Page 19 LU2-4-SF Laser Module Laser Wire 3Pin Ground Wire Thumb Screw *1 Cable Ties *2...