Table of Contents
Installing the Cisco MDS 9148V-K9 Switch
Figure 8: NEBS Kit for 4-Post Installation
1
2
For more information on how to install the switch, see the
the Switch into a 2-Post
Installing the Switch
This section describes how to use the rack mount kit to install the switch into a cabinet or rack that meets the
requirements described in the
Installing the Switch in a 4-Post Rack
To install the switch, you must attach the front and rear mounting guides to the switch, install the slider rails
on the rear of the rack, slide the switch into the slider rails, and secure the switch to the front of the rack.
Typically, the front of the rack is the side that is easiest to access for maintenance.
Before you begin
• Inspect the switch shipment to ensure that you have everything you ordered.
• Make sure that the switch rack-mount kit includes the following parts:
NEBS air baffle
Rack mount
Rack.
Cabinet and Rack Requirements
3
Notch
4
Slot
Installing the Switch in a 4-Post Rack
section.
Cisco MDS 9148V-K9 Switch Hardware Installation Guide
Installing the Switch
and
Installing
23
Table of Contents
