Installation Instructions; Tools You Will Need; Plan The Installation - GE JV694SBB Use And Care & Installation Manual
36″ vented hood
Hide thumbs
Also See for JV694SBB:
- Use and care & installation manual (9 pages) ,
- Installation information (2 pages) ,
- Use and care & installation manual (9 pages)
Table of Contents
TOOLS YOU WILL NEED
Flat blade and Phillips
screwdrivers
Electric drill
Saw (saber or keyhole)
Tape measure
Pliers
Flashlight
PLAN THE INSTALLATION
CAUTION:
Remove the house fuse or open the
circuit breaker before beginning the installation.
Your new hood will fit a standard 36" wide flush bottom
or recessed bottom, framed or frameless kitchen cabinet
which has a minimum depth of 11" from the face to
the inside of the back wall.
The unit is ducted vertically. To change to horizontal
ducting see the instructions.
For safe operation, the mounted hood must be
a minimum of 24" above the cooking surface.
For easiest installation, the range hood should be
installed in the cabinet before mounting the cabinet to
the wall.
NOTE: Remove the glass visor from the unit before
installing the hood in the cabinet to protect the visor
from damage.
This hood can easily be installed by following these basic steps:
• Mark and cut out the cabinet bottom.
• Secure the hood to the cabinet.
• Mount the cabinet on the wall.
• Connect the ductwork and the power cable.
INSTALLATION INSTRUCTIONS
Pencil
Duct tape
Metal snips
(in some applications)
Wire stripper
Level
Caulking
WARNING –
OF FIRE AND TO PROPERLY EXHAUST AIR, BE SURE TO
DUCT AIR OUTSIDE—DO NOT VENT EXHAUST AIR INTO
SPACES WITHIN WALLS OR CEILINGS OR INTO ATTICS,
CRAWL SPACES OR GARAGES.
WORKSHEET—CALCULATE TOTAL
EQUIVALENT DUCTWORK LENGTH
DUCT
EQUIVALENT NUMBER
PIECES
LENGTH
" x 10"
3
1
⁄
1 Ft.
4
Rect.,
straight
" x 10"
3
1
⁄
14 Ft.
4
Rect. 90°
elbow
" x 10"
3
1
⁄
8 Ft.
4
Rect. 45°
elbow
" x 10"
3
⁄
33 Ft.
1
4
Rect. 90°
flat elbow
" x 10"
3
1
⁄
24 Ft.
4
Rect.
(18 ft. w/o
wall cap
damper)
with
damper
Total ductwork
MAXIMUM DUCT LENGTH: For satisfactory air
movement, the total duct length of a 3
duct should not exceed 65 equivalent feet.
TO REDUCE THE RISK
X USED
= TOTAL
x (
)
=
x (
)
=
x (
)
=
x (
)
=
x (
)
=
x (
)
=
=
" x 10" rectangular
⁄
1
4
Ft.
Ft.
Ft.
Ft.
Ft.
Ft.
Ft.
Table of Contents
