Table of Contents
reinstall batteries. This returns the Control Center
to standard operation mode.
Note: The Control Center will automatically return to standard
operation mode after 5 hours.
Low Battery Indicator
The Control Center continuously monitors all the
Sensors. If the Control Center does not receive a signal
from any Sensor it will begin rapidly flashing the Zone
LED indicator . This indicates one or more Sensors in
the Zone may have low battery power and are unable
to transmit a signal the necessary distance. If all
batteries and/or Sensors are installed at the same
time into a Zone, it is recommended to replace the
batteries in all Sensors in the Zone.
However, you can check the Water Leak Sensor status
independently by placing the Control Center in Test
mode (see Testing a Sensor on page 9) and trigger
the Sensor separately (i.e. use a metal paper clip and
touch the contacts). If the Sensor does not trigger an
alert then replace the battery with a new one.
Note: The Sensor detection system is 'range dependant',
which means Sensors located closer to the Control Center
may seem to have batteries that last longer than those
Sensors at a greater distance. The Lithium cell battery in the
Water Leak Sensor can last up to two years.
10
- Quick Links:
- Installation
Hide quick links:
Table of Contents
