Page 1
Read this operator’s manual before using the machine. Contact with rotating parts could be cause injury. Keep clear of the machineuntil alla parts have stopped moving. Damaged or missing parts must be relaced with original spare parts, correctly installed before using. When used at night or in poor visibility, illuminate the area during installation.
Page 2
Pull out the hose perpendicular the machine. Leave always a few wraps on the drum . Start a few wraps by hand on the drum to insure the that first wraps are tight Re-engage the turbine gear by loosening the knob again and sliding the turbine bracket back to the drive gear.
Page 3
Pull out the shut off valve . Attach water source to the inlet joiner of the machine. WATER PRESSURE min. 2 - max. 4 atm. / 60 psi Adjust speed of cart retraction by turning the ball valve at the turbine . Turning the valve fully closed will increase retraction speed.
Page 4
Once the speed is set, the Leader 20 will automa- tically roll the hose on the drum and will shut off at the end of the run utilizing the shuf off valve Leader 20 is ready for a new irrigation...