Quick Links
HPE Synergy 12000 Frame
-48V DC Power Supply
Installation Instructions
©
Copyright 2017, 2019 Hewlett Packard Enterprise Development LP
Part Number: 873191-002
Published: September 2019
Edition: 2
*873191-002*
Overview
This document provides instructions for installing an HPE
Synergy 12000 Frame -48V DC Power Supply.
For more information on frame components and procedures
related to option installation, see the HPE Synergy 12000 Frame
Setup and Installation Guide on the Hewlett Packard Enterprise
website (http://www.hpe.com/info/synergy-docs).
Kit contents
•
Power supply
•
Two (2) compression two-hole lugs
•
Four (4) input terminal screws
•
This document
Mobile documentation
Warnings and cautions
WARNING: To reduce the risk of personal injury from hot
surfaces, allow the power supply or power supply blank to
cool before touching it.
WARNING: To reduce the risk of electric shock or damage
to the equipment, do not connect the power cord to the
power supply until the power supply is installed.
CAUTION: To prevent improper cooling and thermal
damage, do not operate the frame unless all bays are
populated with either a component or a blank.
WARNING: To reduce the risk of electric shock, be sure
that the cable grounding kit is properly installed and
connected to a suitable protective earth terminal before
connecting the power source to the frame .
Page 1
Related Manuals for HP HPE Synergy 12000 Frame
Summary of Contents for HP HPE Synergy 12000 Frame
- Page 1 This document provides instructions for installing an HPE Synergy 12000 Frame -48V DC Power Supply. For more information on frame components and procedures related to option installation, see the HPE Synergy 12000 Frame Setup and Installation Guide on the Hewlett Packard Enterprise HPE Synergy 12000 Frame website (http://www.hpe.com/info/synergy-docs).
- Page 2 DC power source and must be rated no more than 80A. • The HPE Synergy 12000 Frame must be connected to a suitable ground/earth terminal. This terminal must be Using a torque-controlled T25 screwdriver, tighten both connected to a suitable building ground/earth terminal screws to 15lb-in of torque.
- Page 3 name, product version, help edition, and publication date located 15. Remove the output connector cover from the new power on the legal notices page. supply. Notices The information contained herein is subject to change without notice. The only warranties for Hewlett Packard Enterprise products and services are set forth in the express warranty statements accompanying such products and services.