Malibu Boats WF101 General Instructions

GENERAL INSTRUCTIONS FOR WATERFALL USE

1. Unpack the product, wipe off dust with a damp cloth. Take out all

accessories: Bamboo posts, mounting plate, river rocks, and adapter.

2. Familiarize yourself with the pump. Turn valve on pump counter clockwise

placing the handle in a horizontal position for maximum water flow. Turn the

valve on the pump in a vertical position for minimum water flow.

CAUTION: This pump has been evaluated for use with water only.

NOTE: It is recommended the pump be set at its highest flow during assembly

and later adjusted to a lower setting if desired. Be sure to unplug pump before

adjusting flow setting.

WARNING

: RISK OF ELECTRICAL SHOCK

• Do not connect to any voltage other than that shown on the pump.

• This pump is supplied with a grounding conductor and grounding-type attach-

ment plug. To reduce the risk of electric shock, be certain that it is connected

only to a properly grounded, grounding-type receptacle.

• The national electric code requires that a ground fault circuit interrupter (GFCI)

be used in the branch circuit supplying fountain pumps and other pond equip-

ment. See your electrical supplies dealer for this device.

• If the supply cable is damaged it can not be replaced and the pump unit should

be discarded.

WARNING

: RISK OF FIRE

• Do not use with water above 30˚C.

• Do not pump flammable liquids.

3. Insert bamboo post #3 first. Insert the hose from bamboo post #3 through hole #3

on the mounting plate. Make sure to line up the numbers on the post to the

numbers on the plate, turning the post clockwise to lock into place. Proceed with inserting the rest of the posts into the

mounting plate make sure to line up the numbers and turning clockwise to lock into place. Attach the connector tube #3

to the pump located inside the base of the waterfall. Attach the AC adapter jack to the base power cord and tighten.

DO NOT plug into outlet at this time.

NOTE: Do not let pump run when NOT submerged in water. Doing so may damage the pump. Always submerge

the pump in water first, and then plug in the unit.

4. Fill base with distilled water to approximately 1/2" above pump. Use distilled water only. Tap water will create mineral

deposits that will result in the corruption of the Waterfall and pump..

5. Plug cord into 120V household outlet. Turn pump on to verify flow making sure it is not too high and everything is

operating correctly. Arrange river rocks on top of plate.

WARNING: This is not a toy. To avoid danger of choking keep small river rocks away from Children and Pets.

NOTE: Ensure that the electrical cord loop below the electrical outlet." This will prevent water from running down

the cord into the electrical outlet.

MAINTAINING CLEANLINESS AND LIFE OF WATERFALL & PUMP

1. Ensure water pump is kept clean and free of debris. We recommend

using distilled water with this product.

NOTE: To clean pump, first make sure pump is UNPLUGGED

from 120V circuit and remove front plate. After removing the

front plate, the impeller holder must be removed. Remove the

impeller from the pump and check for debris and/or dirt. Rinse

impeller and pump under cold water. Reassemble.

2. Periodically change water and clean the structure of the waterfall

with a mixture of vinegar and cold clean water.

3. Add water to waterfall periodically to keep water level at an optimum

level (approximately 1/2" above pump) to avoid shortening the life of

the pump. Water level should completely cover pump at all times.

NOTE: Never let the pump run dry. This will shorten the life of the pump.

4. To store waterfall after use, unplug the waterfall from the electrical outlet, empty the water, and store in a cool dry

place.

WF101

Impeller Holder

Front Plate

Seal Ring

Regulator

Motorhead

Impeller

Suction Bracket

Shaft