Removing and Replacing a DC PEM
Removing and Replacing a DC PEM
Cisco 12016, Cisco 12416, and Cisco 12816 Router Installation and Configuration Guide
7-60
This section contains the procedure to remove and replace an DC PEM from the
chassis. Before you begin this procedure, read the
section on page
7-29.
Figure 7-36
identifies the components of a 2000 W DC power supply.
Figure 7-36 2000 W DC Power Supply Components
Handle
Circuit breaker
LEDs
PWR OK
PWR OK
FAULT
FAULT
TEMP
TEMP
Captive screw
Ejector lever
Chapter 7
Maintaining the Router
"Installation Guidelines"
OL-11495-01