Repair Instructions; Dismantling The Starter - Husqvarna 445 Workshop Manual
Hide thumbs
Also See for 445:
- Operator's manual (132 pages) ,
- Spare parts (42 pages) ,
- Operator's manual (36 pages)
Table of Contents
7.1 Starter assembly – removal
1
Undo the four bolts that fasten the starter assembly
to the crankcase and lift off the starter assembly.
(see figure 1)
2
Pull out about 30 cm of the cord and fasten it in the
notch in the pulley rim. Release the tension in the
return spring by letting the pulley wind backwards
slowly. (see figure 2)
WARNING!
If the recoil spring is still under
ten i n
hen the pulle i re-
e it can
injury. Wear eye protection.
3
Remove the bolt from the centre of the pulley and
lift off the pulley. (see figure 3)
Cleaning and inspection
Clean the parts and check the following:
•
The starter cord.
That the pawls on the ywheel are undama-
ged, i.e. that they spring back towards the
centre and move freely.
•
Lubricate the return spring with light oil.
7 Repair instructions
ut an cau e
Fig 1
1
Fig 2
Fig 3
Repair instructions
2
25
English –
- Quick Links:
- Carburettor
Hide quick links:
Chapters
Table of Contents
