Table of Contents
Installing a Floppy Disk Drive, Zip Drive, or Tape Drive
1 Remove the computer's cover (refer to
2 Remove the small cover plate on the shelf by unsnapping it first from the right side, and then pulling it out.
3 Check that the mounting rails are attached to the device. If there are no mounting rails attached, use two of the rails
supplied with your computer.
4 Slide the drive completely into the shelf.
5 Connect the power and data cables to the rear of the device (the connectors are shaped to go in one way only). Refer
to
"System Board Connectors" on page 44
6 Secure the device in position using the screws provided with it.
"Removing the Cover" on page
Step 2
for more information about which connectors to use.
2 Installing Accessories in Your Computer
22).
Step 4
Installing Storage Devices
52
Table of Contents
