HP TFT7600 Installation Instructions

Rackmount keyboard and monitor

Hide thumbs Also See for TFT7600:

Installation Instructions

The information contained herein is subject to change without notice. The

only warranties for HP products and services are set forth in the express

warranty statements accompanying such products and services. Nothing

herein should be construed as constituting an additional warranty. HP shall

not be liable for technical or editorial errors or omissions contained herein.

November 2005 (First Edition)

Part Number 365379-001

Audience assumptions

This document is for the person who installs racks and rack

products. This procedure is performed only by trained

personnel. HP assumes you are qualified in performing

installations and trained in recognizing hazards in rack

products.

Page 1: Installation Instructions
© Copyright 2005 Hewlett-Packard Development Company, L.P. The information contained herein is subject to change without notice. The only warranties for HP products and services are set forth in the express warranty statements accompanying such products and services. Nothing herein should be construed as constituting an additional warranty. HP shall not be liable for technical or editorial errors or omissions contained herein.
Page 2: Kit Contents
NOTE: 1U = 1.75 inches or 4.45 cm The TFT7600 RKM is mounted on rails with space available to add a 1U KVM switch box behind the unit.The TFT7600 RKM can be used with all HP 5000 and HP 10000 Series racks.
Page 3 Slide the brace rail assembly in between the HP 1U Adjustable Toolless Rails from the rear of the rack. Align the screw holes on the brace rail with the screw holes on the HP 1U Adjustable Toolless Rails. Secure the brace rail to the HP 1U Adjustable Toolless Rails with two 6-32 screws.