Mounting The Monitor - HP L1750 User Manual

b.

On the single-hinged base, there are three screws that connect the monitor panel to the

pedestal base.

Figure 3-18

4.

Lift up on the pedestal base to remove it from the monitor display head.

HP provides an HP Flat Panel Monitor Quick Release (purchased separately) that installs to the back

of the monitor panel and allows you to quickly and securely attach the panel to a wall or swing arm

mounting fixture. To install the HP Quick Release:

1.

Remove the monitor panel from the pedestal base. Refer to

Base on page 16

CAUTION:

a third-party mounting solution to the monitor, four 4 mm, 0.7 pitch, and 10 mm long screws are

required. Longer screws should not be used because they may damage the monitor. It is important

to verify that the manufacturer's mounting solution is compliant with the VESA standard and is rated

to support the weight of the monitor display panel. For best performance, it is important to use the

power and video cables provided with the monitor.

2.

Set the monitor panel down on a flat, soft, protected surface.

Removing the Single-Hinged Pedestal Base

steps in the previous section.

This monitor supports the VESA industry standard 100 mm mounting holes. To attach

Removing the Monitor Pedestal

Removing the Monitor Pedestal Base

17