Table of Contents
OperatIng the product
C
Time delay function cannot be
set after the programme has
started.
Starting the programme
Close the door of your machine to start it
after selecting the programme and auxiliary
functions.
C
Your machine performs water
softening depending on the
hardness level of the mains
water. Washing time can
change while the programme
is running depending on the
ambient temperature where
your machine is installed,
temperature of the supply water
and amount of the dishes.
C
Pay attention not to open the
door of the machine when it is
running. There may be a rush of
vapour when you open the door
of your machine; be careful.
C
After the rinsing step the
machine will wait silent in pause
mode for some time in order
to have the water remaining in
the machine and on the dishes
drained completely and to have
the water softener cleaned, and
then it will resume running in
drying mode.
Cancelling the programme
Press and hold the Programme Selection
/ Programme Cancel keys for 3 seconds.
Release the key as the Start indicator starts
flashing.
Once you close the door of your machine,
draining is completed in 2 minutes
and the machine gives an audible warning
when it is completed.
30
/40 EN
C
There might be residues of
detergent or rinse aid left in the
machine and/or on the pieces
being washed depending on the
step in which the programme
has been cancelled.
Salt Indicator (
Please check the salt indicator on the display
to see whether there is adequate amount
of softening salt in the dishwasher or not.
You need to refill the salt reservoir with
salt whenever salt indicator appears on the
display of your machine.
C
Adjusting the water hardness
level is explained in Water
Softening System section.
Rinse Aid Indicator ( )
Please check the rinse aid indicator on the
display to see whether there is adequate
amount of rinse aid in the dishwasher or
not. You need to refill the rinse aid reservoir
with rinse aid whenever rinse aid indicator
appears on the display of your machine.
Adjusting the amount of
rinse aid
1.
After turning on your machine, press
and hold the Time Delay and Start /
Pause / Cancel keys respectively.
2. Using the Time Delay key, turn on the 6
LED.
3. You can use the function keys to adjust
the rinse aid level.
If the 1st programme indicator is on, no rinse
aid will be dispensed
If the 2nd programme indicator is on, 1 dose
of rinse aid will be dispensed.
If the 3rd programme indicator is on, 2 doses
of rinse aid will be dispensed.
Dishwasher / User's Manual
)
Table of Contents
