Table of Contents
[Camera] > [Initial Settings]
Setting Initial Video Settings
Sets initial settings, such as video quality compensation, at camera start up. If you change settings, the changes are
immediately reflected in the video display area and Viewer, even if you do not click [Apply].
A message confirms whether you want to display the current camera status as the initial settings if the current camera
status differs from the settings registered as the initial settings when you access [Initial Settings].
If you click [OK], the current camera status is displayed as the initial settings. If you click [Cancel], the current camera
status is ignored and the settings registered as the initial settings are displayed.
Camera Position
Sets the camera position at camera start up.
HM4x H730 S30
Important
If you change the zoom after configuring the intelligent function, privacy mask, preset, and ADSR, those settings must be configured
again.
H730 S80x S90x
Note
• After installing the camera, set the zoom position with the zoom slider in [Initial Settings].
slider is transmitted.
• When [Camera] > [Camera Control] > [Digital Zoom] is set to [Enable] (P. 96), an area indicating digital zoom is displayed in the zoom
slider but not in the zoom slider next to the video display area of the Camera Viewer, etc.
HM4x S30
[Pan/Tilt/Zoom position]
Register the present pan, tilt, and zoom positions as the initial setting. You can operate the frame on the panorama screen
or the video display area to perform pan, tilt, and zoom operations.
HM4x
If you select [Do Not Register], the camera will return to the pan, tilt, and zoom positions as when the camera was turned off
the next time it is booted.
The following settings can be configured here.
• Camera Position
• Camera Settings
S31
Video cropped in the position of the zoom
H730
5
99
Chapters
Table of Contents
Troubleshooting
