Table of Contents
Available languages
Available languages
Interface
connector
IDE Cable
Figure 9. Connecting the IDE Cable
to the Interface Connector
CONNECTING AN AUDIO CABLE
Pin assignment
The pin assignment of the
audio output connector is
as follows.
GND
R-Channel
L-Channe
* Pin assignment of the audio cable
GND
L-Channel
Figure 10. Connecting an Audio Cable
to the Audio Output Connector
Pin 1
Red-edge
GND
l
to Audio
Equipment
(sound card)
GND
R-Channel
Disc Clips
Step 6. Connect the 40-pin IDE Cable to
the back of the CD-ROM Drive.
Please make sure that the red
edge of the IDE Cable is
connected to Pin 1 on the CD-
ROM Drive.
If you want to connect audio equipment or
a sound card to the CD-ROM drive, use
an audio cable to connect the drive to the
sound device.
Audio
Cable
Note: This CD-ROM Drive can be used
vertically.
• To use the drive vertically, open the
drawer and move the 2 plastic clips on
the bottom to hold a disc vertically. After
placing a CD into the tray, move the top 2
plastic clips to hold the top of the CD in
place. Use only standard 12cm discs.
• Do not touch the unlabeled side of the
disc.
E-12
Table of Contents
